May I ask what number you have chosen...

__________________


If you dont live for something...
You die for nothing...

37291

Ok, try this one 12020...Make sure you enter that number in every box that has to have a number entered...Even this one: LimeWire's Port for incoming connections....
Make sure Limew 1 is set for TCP and Limew 2 is set for UDP...
Make sure in Limewire itself you enter 12020 in the manual port forward box and 12020 in the listen box...
Make sure you select Limewire in the drop down box at the end and enable it...
After all that is done shut the comp down and see when you start up Limewire again if the wall has gone...

__________________


If you dont live for something...
You die for nothing...

ok i did all that and its still there where is the option for limewires port for incoming connections

Attachment 2741

__________________


If you dont live for something...
You die for nothing...

i did all of that and its still there

Did you do this bit, it should of appeared after the TCP UDP boxes...
You should see another page of settings that need to be entered into one of the blank lines on your routers Port Range page. Go ahead and enter those settings and then click Next then Close.

__________________


If you dont live for something...
You die for nothing...

ok when i port foward on my dsl modem when i go to enable the limew1 and lime 2 i get a pop up that say click ok for host or cancel for dynamic host=will allow incoming connections on a designated pc dynamic=will only allow outgoing connections on a designated pc thats what it says

hmmmm, which one have you tried....

__________________


If you dont live for something...
You die for nothing...

i clicked cancel for the dynamic but if i click ok it goes to another page and ask for an ip address